Milwaukee pH & ORP Probe Calibration Solution 7.01 & 10.01 - High Accuracy Buffer Solution for Water Testing, Aquariums, Pools, and Hydroponics

Product Description

Pinpoint High Precision pH Calibration Solution sold in single use packets.

Almost all pH monitors and controllers will require two points of reference to accurately monitor the pH that the probe is reading. You will want to use calibration solutions that are on either spectrum of the pH you intend to monitor. For reef tanks where the pH is normally 7.8-8.5 then you would want to use calibration solution 7.0 and 10.01. For calcium reactors on saltwater tanks or freshwater aquariums where the pH is normally below 7.0, you would want to use 4.01 and 7.01 for calibration of the probe.

4.01 pH - The lower threshold reading your pH monitor or controller will require for use with calcium reactors for saltwater aquariums, solutions below 7.00 pH and also most freshwater aquariums.

7.01 pH - Neutral pH calibration packet. This is used by almost all pH monitors and controllers for calibration. 

10.01 pH - The higher threshold reading your pH monitor or controller will require for use with saltwater aquariums or solutions above 7.00 pH

Calibration packets can be stored in a cool dry area for up to 1 year.

Another American Marine first. ORP/REDOX calibration fluid. With a precise measurement of 400mV, this calibration fluid is included with every PINPOINT®ORP Monitor and PINPOINT®ORP Controller. Occasional retesting with this fluid will keep your readings dead-on accurate. Also very useful to determine if an ORP/REDOX probe is ready for replacement.